Router Jointer

[jcclark]

I know this may make some cringe but it is the best joining method I've
tried, and used correctly, perfectly safe.
It's only for shaving off less than 1/16 at a time.
With a 4' straightedge I can get narrow stock, like 1 1/2" wide,
perfectly straight up to 6' long.
I have a Powermatic long bed jointer and it can't come close to
the straightening that this router setup does.



I usually first cut my stock 1/16" wider than I need.
There's a threaded rod mounted to the fence I turn to tighten
the distance a fraction at a time.
(The entire fence is clamped so it can accomodate up to about 10")



I can get a perfect match everytime this way and all my stock
for rails, styles and frames are always exactly the same width.
And perfectly parallel. Can't do that on a jointer.
Also, I usually get to within .001" for the width.
It may be extreme, but it can help in some cases.

[Don]

Nice setup and picture, JC. I would guess that you start with pretty straight material from your jointer to begin with though, right?

Another option for those that have one of those bench top planers, (smooth bottom bed with no rollers) is to slightly oversize your material for width and run the material through on egde. Perfect for faceframe parts up to around 2" in width or less. Just start with one square and straight edge and the results will be similar to your setup.

Thanks for sharing your method.

All the best, Don

[jcclark]

Yes, it's actually pretty straight right off my saw
(since I finally got a good fence for it).

Also, with this method, I'm always pulling stock
against the fence (away from the cutter)
keeping my fingers safe when running stock.

The router cuts so smooth I hardly ever need to
sand the edges for my frames.

[thekl0wn]

I should've came by and checked out the jcclark shop when I was in Louisville this Spring!

This is actually the method I've used... We have a nice 8" joiner that I've never learned the proper method to use properly.

[jcclark]

I wish you had, I don't know anyone hear to talk
wood with.
I would enjoy anyone stopping by to talk wood
and let me show off all my toys (tools)

[AMF]

Originally Posted by Don

Nice setup and picture, JC. I would guess that you start with pretty straight material from your jointer to begin with though, right?

Another option for those that have one of those bench top planers, (smooth bottom bed with no rollers) is to slightly oversize your material for width and run the material through on egde. Perfect for faceframe parts up to around 2" in width or less. Just start with one square and straight edge and the results will be similar to your setup.

Thanks for sharing your method.

All the best, Don

I try and "edge" plane all my parts when I can. Makes for nice crisp edges and uniform pieces, I also find it easier to sand off Planer markes than it is to sand off saw blade marks.

Cheers, Alex